Roland's homepage

My random knot in the Web

Articles about work

  1. Making a composite plug or mould

    For the bus rear floor we initially made a prototype mould. This was done because of time constraints and because we weren’t sure that there wouldn’t be changes to the design.

    Now that the design is frozen it is time to make a fiberglass mould. This is done ...

  2. Sandwich floor panel for a bus

    For the same bus that we made the rear floor panel for, we also made a composite floor panel.

    Again we used vacuum infusion to make the prototype. The picture below was taken appoxtimately halfway through the infusion process. In the rear half of the product the resin has infused ...

  3. Rear floor for a bus

    Today we made the first prototype for a rear floor panel for a bus. It is quite a big part. The mould was so big it didn’t fit our milling machine, so we had to make it in two pieces.

    It is a relatively complex part as well, a ...


Page 1 / 1